Cab & Chassis Models
The above prices include the following:
- Fitting of new tray to Ute
- Number plate installed if supplied
- LED number plate light supplied(fitted and connected) on most models
- Tail lights that are supplied with cab and chassis models fitted and connected
- LED Tail light option available
- Hot Dipped Galvanized Steel Mudguards
- Mudflaps – Supplied & Fitted
- Fuel filer relocated and raised for quicker filing
- Backboard higher than sideboards
- Mud scraper incorporated ni steps-both sides
- Prompt supply and turnaround subject to workload
Optional Extras:
- Tail lights – to replace factory lights (incandescent) – $180 per pair
- Tail lights – fully sealed, flush mounted, LED multi-volt complete with inbuilt resistors – $190 per each
- Patch wiring loom extension – $90-$240 per set (depending on model)
- Mounting bar for rear sensors – $POA
- Make mounting bracket, install & position reversing camera – $80 pc sum
- Mount spare wheel against headboard (Landcruiser or similar) – $90
- Rear “H” Frame (includes drop-in pockets in tray) – $430
- Hydraulic Tipper – options available – $POA
- Storage/Toolboxes (right &left) mounted behind mudguards on double cab utes – $490 fitted per each
- Handwash water tank & soap dispenser – $390 fitted
All prices exclude GST
Wellside Models
The above prices include the following:
- Removal of wellside from Ute, disconnect wiring, fuel filler connection & cable, detach reversing camera. number plate &tail lights including bumper sensors (where applicable)
- Cable-operated fuel filler flaps will be disconnected and may need to be removed or deleted by Dealership
- Fitting of new tray to ute
- Number plate installed – if supplied
- LED number plate light supplied (fitted & connected) on most models
- Factory tail lights fitted to wellsides are NOT compatible
- After market tail lights need to be fitted – see options
- Heavy hot dipped galvanised mudgards
- Mudflaps supplied and installed
- Fuel filler is relocated and raised for quicker filling
- Robust headboard (removable)
- Prompt supply and turnaround
Optional Extras:
- Tail lights – to replace factory lights (incandescent) – $180 per pair
- Tail lights – fully sealed, flush mounted, LED multi-volt complete with inbuilt resistors – $190 per each
- Patch wiring loom extension – $90-$240 per set (depending on model)
- Mounting bar for rear sensors – $POA
- Make mounting bracket, install & position reversing camera – $ 80 pc sum
- Mount spare wheel against headboard (Landcruiser or similar) – $90
- Rear “H” Frame (includes drop-in pockets in tray) – $430
- Hydraulic Tipper – options available – $POA
- Storage/Toolboxes (right & left) mounted behind mudguards on double cab utes – $490 fitted per each
- Handwash water tank &soap dispenser – $390 fitted
Note:
- A lockable fuel filer cap may be required
- Utes with bumper sensors will be disconnected/unplugged (this may come up on the dash as a fault) this would be the dealerships responsibility.
- All wellside utes require aftermarket tail lights – See options
- We require an order number to be provided at time of the order. Please indicate colour of vehicle and purchaser’s surname as a reference to avoid any confusion or mix-ups as we often have 2-6 utes in the workshop at any one time
- There is normally no charge for the removal of wellside trays however Armourshield Engineering normally retains possession of surplus wellside deck items. Should the wellside be required by the owner – this needs to be expressed at the time of order and will incur a further charge
All prices exclude GST
